Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, My situation is the following. I have a Windows VPN client 4.0.1 trying to authenticate with digital certificates to a 3005 concentrator. I have installed the CA on both, identity certificate on the 3005 as well. I enrolled a certificate w...
Hello everyone, I dont have that much experience yet with VPN configs, so maybe this question will seem a bit silly. I have a Cisco 831 which I use to connect via VPN to a remote site. All works well.Then I wanted to add a second tunnel to another lo...
Hello all, I have some problems getting GLBP to work. I have to Cisco 3725, each with a T3 line. I have setup GLBP as following:Router1-------interface FastEthernet0/1 ip address 10.32.5.2 255.255.255.0 no ip route-cache no ip mroute-cache duplex aut...
Hello all, I have 2 locations connected via 2 DS3 lines, for redundancy. Each site has 2 3725's with 1 DS3 per router, using 2 different carriers. At the moment I have configured HSRP at each side and all is working fine, maximum bandwidth is 45Mbps...
Hello all, Is it possible to use a EtherSwitch network module in a Cisco 2611XM and then use EtherChannel to connect to a Cisco 2950 switch ?Thanks,Stefan
I have downloaded, compiled and installed a Sourceforge.net project, openCA (http://www.openca.org/openca/). Won't help you if you have a Windows box though. But in my case was perfect, runs fine on Linux and it's free. If you dont mind the fact that...
Well, problem solved. I have installed a different CA system, re-issued all certificates (CA's, for the 3005, for the VPN client) and everything is working now.
Hello, To be honest I dont know how to check whether the hash is the same or not. Not sure where is the hash involved in certificate authentication. Any pointers on this would be appreciated. And yes, I have found that link too but it's not much help...
