Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI need help concerning external database configuration.....actually I want to configure ACS to athenticate users based on domain databasewhen I check on ACS servises I cannot see CSAgent and it looks like I need the API and this CSAgent to can run ...
I've configured firewall to use ACS but the firewall locks me ou when the ACS is nt availablemy question is is there any command i hae to configure on the firewal to be able to get to it when the ACS is unavailableanother question is I cannot run fir...
I have problem with the following platfoms,router 7500 ,1700 and 2600,siwtch 2900. they just loose configurations sometimes this happens after power failure(most cases)and few were it just happen.my question is what can be the cause of this and if th...
Hi guysI need help on this two casescase oneI have a cisco 1750 router connect strait to the pc using a crossover from the router to the conveter and a straight cable from the conveter to the pcbut this lan is not coming up.when i do sh f0 it shows u...
Hii need help,Im trying to setup appletalk to work on wan over aurp,with eigrp all works fine but when I disable eigrp and use aurp protocol i do not see neighbors here is how my configs looks like,I'm I missing something hereinterface Tunnel41 descr...
may be I didnt clear something here, this is happening on the routers were configs are been saved,routers like a 7500 as a distribution configs can be save many times due to when we add new sites but when it re-boots it loose everyting and the config...
HiI need help, i have a cisco 6500 and I want to implement access-list on a v-lanas a scenario, lets say I have port 3/7 on v-lan 3 and on this port a server is connected.but I want to allow only one network to pass and deny anything else. beacuse no...
HiI need help, i have a cisco 6500 and I want to implement access-list on a v-lanas a scenario, lets say I have port 3/7 on v-lan 3 and on this port a server is connected.but I want to allow only one network to pass and deny anything else. beacuse no...
Hi i also think the way you set up your diagrams will be of help to me toomay you please also send me the sample so that I get a hint when I draw our network this will be of great helpmy e-mail address is rsiriba@yahoo.comthank you(in advance)
