Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 7500 that connects to a 7600 using a PA-FE-TX interface and I'm using MPLS. When I set the MPLS mtu on the 7600 it requires me to adjust the interface MTU (6700 series switch card) as well (from 1500 to 1524). The 7500 will allow me to sen...
I've been troubleshooting this for hours and I just can't figure this one out. I have 3 7200vxr NPEG1 routers that each have a single ethernet connection to a 6500. VXR1 has it's gige interface sub-interfaced into vlan2,3 with dot1q encapsulation. ...
which APC rectifier did you purchase? I'm looking to put in an ons 15454 in a new facility and need a recommendation. this could expand to 3 units so a scalable DC retifier is prefered.Thanks
Yep - I can ping the interfaces, but when I ping the ospf multicast address from VXR1, VXR3 does not respond. I wonder if the 6500 is preventing this from going through. I'll keep digging.
