Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 2811 router and both it's fastethernet interface input errors are increasing all the time. There are some middle buffer failures but it's not increasing as much as compared to the interface ignored errors. CPU utilization is around 30% on...
Hi,I have a WAN router with 2 ethernet interfaces.I've configured floating static route to route packet to a gateway outethernet0 and a backup route to another gateway out ethernet1.If ethernet0 interface is down, the router will use the backup route...
Hi,need advise on how to find out the cause of my C2924XL-A rebooting.I did a show version and it shows:System restarted by reloadWhat other commands can I use to find out the exact cause insteadof a generic reload.Thanks
I have a PIX 515E that keeps hanging.I found that 2 ethernet interfaces are having the same IRQ.Will that cause the unit to hang?Here's the output of show hardware:Cisco PIX Firewall Version 6.1(3)Cisco PIX Device Manager Version 1.1(2)Compiled on Fr...
one of the gateway is a windows 2000 server and the othera pix firewall.I am not sure if i can create a tunnel between the routerand the windows 2000 server.
Thanks,I've search through the pages and found no match for field replacement.However, after I changed the FE card, the firewall runs fine.I think it is a case of faulty card.
