Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently we have two older applications using sql that inhouse run in less than two seconds. Over the waas and 60 ms latency run 3 to 4 minutes. I am looking for any assitance on this. We have tried changing from passthrough to full optimization.
Can you go from a network via Pix 515 to Pix 506 and administer the 506 on the inside interface. I am able to get the outside address working but not the inside.
I have a 6509 with 2 msfc cards and would like to setup dhcp for 10 vlans. We set up ip helper addresses on the vlans and dhcp is working but I am seeing duals broadcast because we have the configs the same on both msfc cards. Is there a differant wa...
We have the same situation running Onbase sql calls. We tried altering the setting from pass through on up. No luck for getting better throughput. Our are ms-sql calls with 65ms latency
For my 7200 TAC suggested 12.2-11T9. I opened a TAC case with the show ver included and they recommended the version for each - not the best way to do it but it is very confusing as to which version is ok.
