Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
AP 3800i showing on WLC5520 "PoE/Medium Power (15.4 W)" connected with switch Catalyst 9300. I have 36 APs connected on WLC 5520 but only 6 APs show the protocols Down "PoE/Medium Power (15.4 W)"..
Hi,I was trying connect the two devices (MS-250 with MX-100), but i don´t see option to aggregation port connection on MX100 device? Is it possible to use this connection aggregated in 2 ports for each device?
Prezados Boa tarde,
Estou tentando configurar dois endereços IPs virtuais dentro de uma sub-interface de rede, ou seja, um endereço IP primário e outro endereço IP secundário em uma interface com o modo de redundância rii (ZBF), porém, essa op...
Yes. We solved the problem. I enabled the CDP command on All AP´s connected directly on switch and I forced the command duplex full in the ports. After these commands the APs are working fine.
Hi Leo,
For me is critical case because the APs showing the Status Down (2.4GHz and 5GHz) not working with POE Medium power (15.4w).
I have a open case on Cisco TAC support about this issues.
Thank you for your help!
The Firmware is 8.3.141.0Follow the output command:BRCSF-HQTI-AC19-01#show power inline Module Available Used Remaining (Watts) (Watts) (Watts) ------ --------- -------- ---------1 1590.0 227.0 1363....
