Can somebody tell me how can I manually clear a NAT sessions after I disconnect from my partner. When I disconnect from the VPN the NAT session still exists in the vpn and does not time out. What is the timeout for the NAT statement. I thought if ...

I have set up HP 4000M swich to use Tacacs+ Authentication and it works fine. Now I need to figure out how to block access to those swiches using groups in ACS. I tried using NAR (network Access restriction) but was not able to achive desired result...

I have configured cable Failover using as well as statefull failover using a crossover cable. The failover works fine but the state does not. When I transfering a big FTP file and pull an ethernet cable from the active unit it failsover to the stan...

We just received Sup2/MSFC2 to run with IDSMv2. What IOS we need to install? From what I understand from the documentation we need 12.1(19)E or 12.2(14)SY. IOS 12.2(14)SY requires much more memory (256)and its alomost 30 megs of flash. 12.1(22)E1 ...

I installed IDSM v2 in my 6509 switch. I run a setup command and configured control interface and assigned an ip address to it. However, I can't ping it from any of my workstations. I did not apply any access-list to it. I think I know why I can't ...