Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have ran these debug commands and below is the output the I recieved.debug mac addr AP MAC ADDRESSdebug capwap event enabledebug capwap errors enabledebug capwap detail enabledebug PM PKI enabledebug DTLS Event Enable *spamApTask1: Apr 24 13:35:35...
Hello, I'm curios as though any one has been able to engineer a work around for the iWAN app's in the APIC-EM inability to support VPLS. Thanks in advance.
Our network is having issue when we attempt to do a failover situation in between our two Hubs. The primary tunnel is configured as follows.
!interface Tunnel1 description ***DMVPN TUNNEL -VPLS TRANSPORT*** bandwidth 250000 ip address 192.168.101.1...
Hello everyone,
Just trying to get some feedback on this configuration that I am trying to implement and trying to see if any of you have encountered this issue.I have a Cisco 2960X that I will be using as a DHCP server at a remote site. This switc...
Several of the APs that are refusing to join the WLC have Cisco IOS Software, C3500 Software (AP3G1-K9W8-M), Version 15.3(3)JA12, RELEASE SOFTWARE (fc2). At this point I think the best bet would to have TAC look at this but I truly appreciate the tho...
That's probably what I will have to do, I am trying to figure out if there are any compatibility issues between the WLC and the AP but I can't seem to find anything that points to that as the issue.
That is correct, the SVIs reside on the same switch and there are no VACLs implemented. The weird thing is that there are two APs on the same VLAN that ARE joined with the WLC.
