Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hopefully, this will be an easy one for you guys n girls...I've got a stack of 3x3750 switches working as one.Also, i've got a 2960 switch at another site, connected by a LES circuit.I've got several VLANs already setup on the main switch stack that ...
Hi all,Newbie here, so be gentle...I've got a PIX v7.2(3).This is connected to a LES 100 connection uncontended(UK), this has been capped to 20Meg. So far, so good...Thing is, I'm sure the speeds we're getting are definitely not 20Meg. I've ran loads...
Hi all,Sorry if this is the wrong area.I cant get past the first hurdle, setting a hostname for the router!I have a 837 router with Version 12.3(2)XC2 IOS.But it doesn't recognise the 'hostname' command.Can anyone help please?
Can anyone please help?I've got a Cisco 3725 ISDN router.I have two serial connections going to ISDN30 units (BT). I'm UYK based.I've just had BT cancel 50 of the 60 channels as we don't need them any more.But now, I can't ping most of the the remote...
Here's a wierd one...I'm in the process of renumbering the LAN.I've got two VLANs that can talk to each other.I have 3 3725 switches (stackwise) with about 5 2960 switches uplinking to the 3725s.These 2960s connect to ports on the 3725 that are in VL...
Well, I though I had it...I've deleted it all in an attempt to add a more meaningful name to the VLAN, but I can't seem to do it.I'm doing-conf tvlan But i get some errors when doing this.Can you help at all?thank you..
Kevin,Got it! (I hope!!)From your post, I went back and did a vlan30, sure it appeared straight away in the sh vlan.I then did an int vlan30 and added a description and IP address.It appeared on the remote 2960G switch and I can ping it from the LAN ...
Hi Kevin,thank you for your advise...and when I do a sh vlan, the VLAN isn't even there, just as you mentioned!Where did I go wrong? I am a novice so I've definitley missed something.Can you help please?Thank you..
Thanks for getting back to me.I'm just downloading the free MRTG app right now.As for the SNMP stuff, how and what do I need to configure on the PIX to get it working?Is there a standard small config i can enter, can you possibly post it here?Thanks ...
Thanks for checking this and your reply.But, I had to remove all voice type fixups when I first set this all up, and it did work just fine.And now, it's all gone wrong It works just fine on the LAN, it's only when I connect using the VPL client.I ju...
