Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have 2 wan links terminating on a cisco 2621 router with 2 different subnets.How do i configure pix firewall to integrate the 2 different subnets of isp's andimplement the security policies between the internal lan and outside world.Regards,n.s....
Hi,Understand that catalyst 4006 switch has 64 Gbps backplane speed.Also understand from the maximum port density table of catalyst 4006 as10/100 - 240 ports, 100 Base FX - 240 ports.Also understand that this switch supports 10/100/1000 - 240 ports....
Hi,I have two catalyst 4006 switches with Sup2 and Layer 3 module in each switch. I have configured the following vlans on two switches as follows.Switch 1:Vlan 1: 10.1.1.0/24Vlan 2: 10.1.2.0/24Vlan 3: 10.1.3.0/24Switch 2:Vlan 4: 10.1.4.0/24Vlan 5: 1...
Hi,Can you elaborate on the v.25 bis dialling. Understand from the TA manual that the protocols supported are V.110, V.120, PPP 64k, MP-PPP 128K,X.75, X.25 on D, Soft-Fax, Channel Bundling, BACP/BOD.Regards,ravishankar
Hi, I would like to highlight the exact scenario... cisco 1751-V(wic-2a/s) | router is connected to TA through the following cables...cab-ss-rs232mte to 25pin(female) to 9 pin(female) converter ----> 9 pin(female) to 9 pin(female) to TA D-Link ISDN T...
Dear Tejal,I am trying the same on wic-2a/s ports and in combination with D-Link TA(model:DMI-128ESU). I am unable to carry out v.25 bis dialling option. I am using CAB-RS232MTE cable with DB25(Female) to DB9(male) converter and DB9(Female) to DB9(Fe...
Hi,Thanks for the info....But do we have any scenario or stand configuration set that needs to be done to implement this solution.regards,n.s.ravishankar
