Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This might be in the wrong location. I am replacing a failed Hard Drive on a Prime Infrastructure Appliance (Gen 2). Is there a set of instructions on how to proceed with this replacement?
Question - Is this an expected action? I have attempted to reestablish Telnet access using the "line vty 0 4" commands. The CLI commands indicated that they executed correctly, but the Telnet connections are still being refused.
I recently did a Factory-Reset All on a misconfigured C9200L 24PXE switch. I downloaded the latest IOS bin file from Cisco and I can install it via the USBFlash0: However, When I try to copy the bin file to Bootflash: There is no BootFlash: Direct...
Sorry, but no. I don't have any previous config copies for these systems. How do I go about making changes to the transport input settings? Just to test, I ran an upgrade on a Cisco C9200L-24PXE-4X to iosxe17.03.03 - Once completed and the system...
I've currently have had this happen on two systems: Cisco C9200L-24p-4x and Cisco C9200L-48p-4GThis is the output for vty on these systems: From 48P:line con 0stopbits 1line aux 0stopbits 1line vty 0 4password 7 15051804517F7872loginlength 0transpor...
"Emergency-install" is not recognized as a valid command. Plus, you indicate that I need to install the file into bootflash. I do not have a bootflash directory.
