About LNavaraj

LNavaraj · 05-20-2003

I configured PVLANs in my CAT 6509 ( Primary & Secondary -Community) and tried to extend to another CAT 2924 XL switch through a Trunk port. The Host which is connected on 6509 promiscuous port (which is mapped for the primary VLAN) can be accessed...

LNavaraj · 11-25-2002

Hi, Will PIX 515 allow Packets coming through IPSec tunnel, from the outside interface to the DMZ interface? Have any idea? Securiy levels of the interfaces are as follows.nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ...

LNavaraj · 07-26-2002

How to recover password in PIX 506,515 firewalls?!!

LNavaraj · 02-15-2002

Hi, am wondering whether Cisco supports Nested tunneling?! i mean Tunnel inside Tunnel ( IPSec - 3DES). Any body has got any idea?Host A --> RouterA --> Concentrator 3030 -->PIX515 -->RouterB -->HostBThe Outer Tunnel is between Concentrator 3030 and ...

LNavaraj · 11-26-2002

Yes it is working fine, I just added the statement "nat (intf2) 0 access-list 160" in my current config without altering anything else and i am able to access the DMZ host from the remote VPN net (10.3.9.0). I don't think we need to have two separ...

LNavaraj · 11-26-2002

Here is my PIX config. My DMZ host IP is 192.168.22.20 which is connected through intf2. I am able to access this DMZ host from my internal Net 10.3.111.0 but not from my remote VPN Net 10.3.9.0. Let me know if you have any clue. Thanx much..NB: The...

LNavaraj · 11-25-2002

Thanks for your response. I am talking about terminating the tunnel on the pix itself. In my case, I need to route packets from my inside interface & also from my outside interface ( coming through tunnel) to the DMZ interface. Let me give a shot.

LNavaraj · 03-03-2002

Finally I found a solution for this problem with a help of Cisco TAC. VPN 3060 does not pass IPSec traffic through inside interface. But when we tried with Cisco Router, it worked fine. Cisco says that, in theory VPN 3060 suppose to work in my scena...

LNavaraj · 02-23-2002

The concentrator does not seems to be passing the trafic when i initiate the tunnel from Router A side though i configured to allow all traffic.(My privte interface (internal) filter is any any..) Do you have any ideas?!!

Member Since	‎07-12-2001 07:21 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	10

User Statistics

User Activity

PVLAN ( Private VLAN ) across Switches

IPSec Tunnel & DMZ

PIX 506, 515

Nested Tunnel - Tunnel inside Tunel

Re: IPSec Tunnel & DMZ

Re: IPSec Tunnel & DMZ

Re: IPSec Tunnel & DMZ

Re: Nested Tunnel - Tunnel inside Tunel

Re: Nested Tunnel - Tunnel inside Tunel