Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've searched for information on grounding of cisco switches on this forum, but found the answers vague.
Is it necessary to run a separate ground from the switch to the cabinet chassis and if so where do you connect (most switches don't have groundin...
I just added a new 5510 failover unit to an existing 5510 and when connecting my new outside interface on an Active/Standby firewall pair, i get errors messages (red x) on each port scan (monitor & syslog) although the error message indicate all port...
I understand that the track command is a compliment to HSRP in that it allows monitoring of a given interface to provide failover to a standby router. Isn't this what HSRP does, how is tracking differentiated from HSRP functionality....I've tried fin...
Hi,Can I setup a public VPN on an addtional outside interface for webvpn access, I'm currently using the 5510 firewall as a private firewall within a corporate LAN...are there any special considerations?.
That makes sense Rick, thanksIn the example I am tracking the hsrp gig1/0/10 and gig1/0/11 ports, I probably should be only tracking the non-hsrp ports.
Thanks Amit I appreciate the patience,so if I didn't include the track commands as above, in the event of an interface failure the failover would not occur?...or is my track command redundant?
Thanks guys,so if i don't specify any object in my tracking command, it would amount to the same function as HSRP...see below;interface GigabitEthernet1/0/10description L3no switchportip address 172.27.36.2 255.255.255.0no ip redirectsno ip proxy-ar...
