Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,ASA Software Version 9.1(7)23Cisco ASA 5520We ran a test for our VPN firewall on Qualys website and it showed some week configuration points. i.e. TLS1.2 is not enable TLS1.0 is enable. I understand TLS1.2 is not supported in this version.Under t...
***Foreign & Anchor WLC 5800 ver: 8.2.166.0*** I have 4 WLCs. 2x WLC in HA as foreign controllers. 2x Anchors in DMZ. On the foreign and anchor WLCs, there are two guest SSIDs configured. Guest1 and Guest2. For each guest SSIDs in foreign, WLAN > M...
Foreign & Anchor WLC 5800 ver: 8.2.166.0We have SSID for guests, 'visitors_HQ' that is centrally switch and egress from HQ with webauth enable. This SSID is tied to WLC interface 'inf_guest' on Foreign and Anchor controllers.We also have 'employee' S...
# show run | i cipher<empty>(config)# ssl cipher ?ERROR: % Unrecognized commandI see that tls 1.2 support starts from 9.3 but in software download page of 5520, the last update was back in 2018 and it was 9.1(7)This means new hardware is needed to us...
This is Cisco ASA 5520. I know this is pretty old and not supported any more. Before I consider to make changes to protocol or OS version, i was looking where these are defined, either in ASDM or CLI. That i can't find. Google says that I should see,...