About thearties

thearties · 04-16-2025

Seeing a post on Meraki Status about 'MX Unexpectedly Rebooting'. Anyone affected?

thearties · 04-15-2025

Hi All, Would like to see whether this is 'normal' for everyoneFrom the clients page of a device, device policy is set to Blocked (all), followed by Save. I gave it 5 min and then click disconnect client. I then waited another 5 min and refresh the p...

thearties · 10-19-2024

Good y'all.I'm currently having some issue with these above 2 models.When the MR46 are plugged into the switchports, none of MR46 power up. No lights whatsoever on the switchports / MR. Cable test seems to be good (all 4 pairs lights up and correct)....

thearties · 08-15-2024

Would like to understand the traffic flow priority here. Say that I have a spoke site connecting to a hub with full tunnel auto vpn setup. And one of the LAN vlan e.g. vlan x is enabled for VPN. Am I still able to use the 1:1 NAT to point to an IP in...

thearties · 04-01-2024

Greetings All. Came online and noticed one of the remote network's WAN 1 was showing 'failed' status. Checked and discovered it was caused by a 'disruption' in the existing DNS (provided by ISP). Changed to Google DNS and line came back up. At the sa...

thearties · 06-22-2025

Hi there.With your reply, it kinda strengthen my assumption. Coz until now (even after RMA) mine still doesn't really power up the WAP on the ceiling. But then when its connected using a patch cable in front of the 130, it works fine. Right now we ar...

thearties · 04-15-2025

Thanks for the prompt reply and sharing. Is there a way to prevent that particular device from successfully connecting?I do not want to change the password (as it will affect other devices), but I want to "flush" this device out so that I can remove ...

thearties · 10-19-2024

Checked the switchport physically and there is no light at all. Also rebooted the switch many times.Also tested with other POE device and the same ports work i.e. power + connectivity.Forgot to mention this is a new RMA unit. Now I wondering, is ther...

thearties · 10-19-2024

By default POE is already enabled.And power usage is just 7.82 W / 370 W.Btw it's only 3 WAPs.Anything else to check?

thearties · 08-20-2024

Hi Tony, Thanks for the reply. Based on your drawing, I'm trying to see whether its possible to publish a server in the vlan 20 via MX2 using the 1:1Nat. I understand that by doing default route under site to site VPN, everything goes out via MX1. He...

Member Since	‎10-26-2017 07:38 PM
Date Last Visited	‎10-26-2017 11:00 PM
Posts	24
Total Helpful Votes Received	15

User Statistics

User Activity

MX Unexpectedly Rebooting Reported on Meraki Status Portal

Is the device really blocked?

MS130-24P & MR46

Full Site to Site VPN vs 1:1 NAT

MX Uplink DNS Behaviour

Re: MS130-24P & MR46

Re: Is the device really blocked?

Re: MS130-24P & MR46

Re: MS130-24P & MR46

Re: Full Site to Site VPN vs 1:1 NAT