Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am confused please clear my doubts.Eigrp is running in my network and if I have 3 destination network 192.168.0.0/24, 172.16.1.0/24 and 10.1.1.0/24 and for all these three destinations 4 best routes are installed in the routing table. Now I want...
Hi everyone,I am getting loop in my network inspite of running pvst.PVST is running on two switches that are connected to each other through etherchannel po1.on one switch root port is po1 as it priority is high. similar configuration is done on othe...
hi,This is not a very technical issue but if anyone can help/ suggess me its realy helpful for us.In our environment we have 24 cisco switches and everyday we need to login into each switch to check the uptime of the switch, that is very time consumi...
HI everybody,today while reading about ether channel I come to know that in pagp or lacp (auto or desirable mode) we can check the no of packet sent and recieved at the individual interfaces configured in etherchannel.by using command show pagp 1 cou...
Hi,I am doing lab on GNS and having a very simple scenario, but i am stuck somewhere...lab diag is attached....in MPLS clous OSPF is the IGP used... CE is communicated to PE through static routing.Problem : unable to ping LAN of R1 through R4(PE) eve...
But dont understand why are you adding deny acl.access-list 101 deny ip 10.10.2.0 0.0.0.255 192.168.1.0 0.0.0.255yes if you add any network in lan you need to permit it in acl 101
Dear Islam,It seems your NAT configuration is not working because Public IP is not configured at the WAN interface of your IslamVPN router.Configure the Public IP on the WAN interfaceAdd interface command at IslamVPN"ip nat outside" at WAN interface"...
Hi,As a work around, If static NATing is deffined for few servers you then you can remove those fron dynamic nating by using ACL for dynamic NATpool For clear picture please share the nat translationThanksShashi
hi,The logs shows that both the routers are not communicating to each other for hsrp as no hello packet are seen.please send sh cdo neighbour so that we can get the information about the connectivity.ThanksShashi
Hi,switch2 connected to ISP switch that is acting as a root.but this will happen only when he is also running vlan 80 and pvst. Am I right???Also please let me know if any problem in making my Sw1 or Sw2 as a root.ThanksShashi Mishra
