Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All!I have been looking everywhere for a clear description of how to see/zone/manage virtual WWNs with NPIV on my Cisco 9509 switches and I can't find anything that actually details the zoning best practices or how to see the virtual WWNs. Thi...
Hello All!I did some looking around the forums and found what I think might explain the behavior we ran across today, but I wanted to ask the experts to see if we are on the right track. Here is what we saw:We had a 3550 switch and a 3745 router. B...
Hello All!I have been reading the posts both current and old regarding the shutting down of VLAN1 and the use of the switchport trunk native command. We have been asked to harden a number of switches in our enviornment and shutting down VLAN1 was th...
Hello All!I have done some searching in the forums regarding my question, but I can't find anything conclusive here or in the documentation. Here are the particulars with my setup: 1. Each PIX535 firewall pair running 8.0(3) with 8 interfaces (2FE a...
Hello All:We are looking to add a second 7606 router to our current configuration (we are currently running a single 7606 router) so that we will have some redundancy at our core. I have been putting together an implementation plan for the insertion...
Jacob, hello and Happy New Year's Eve! You might already know this, but the 7.6 code was just released a few days ago on December 20th I believe and it is currently available for download. Best of luck and enjoy the 3702s!Cheers,Travis
Hello!No, we are doing EVERYTHING from a 64GB hyper on our EMC DMX-4...bootingfrom SAN the whole way. We got sidetracked with some other issuesyesterday, but this is #1 on our list this morning...I will definitelypost our config and any other inform...
Mark:Hello! We actually have it working now (I just haven't had the time toupdate my post)...I will be sending you the details today though. Itdidn't log in to the fabric until we built an image and brought it up. I will get all the details from my...
Brian:Hello and thank you for the reply! I was actually just getting ready to post up some follow on information as I just heard back from Cisco support on the issue. The engineer assigned to the case suggested the following:On core switch : this ...
Jon/All:I just wanted to say 'Thank you!!!' for the assistance! I implemented the fix today for our PIX535 firewalls by adding in the standby IPs for the interfaces that were missing them. Worked perfectly and interestingly, the switchports and tru...
