Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two CSS switches seperated across a WAN (T1 private line) link. Is it possible to configure the routers on either end to bridge the traffic, so that I can run VRRP and configure VIP redundancy? Has anyone done this before?Basically I have a ...
I'm wondering when (if) Gateway Load-Balancing Protocol will become a standard in IOS? What platforms is it currently supported on (if any) and in what IOS versions? Are there plans to implement it on all platforms?Finally, is there currently any...
Ok, here goes:I am using http get method for service availability. Scenario:I connect to the content rule on port 80.I then transition all the services to down by renaming my index.asp file (the file used for my http gets). I then verify that my s...
We use (as another poster pointed out) the lightpointe flightstrat 1.2G product to connect two buildings about 1KM from each other. The four rotating lasers in the unit ensure that weather is not a problem. The capacity is 1.2G.
Do you have a source group configured on your css with the same VIP address you use in your content rule? Is application ftp configured on your content rule?
