the below is sh version
cisco AIR-AP1815I-E-K9 ARMv7 Processor rev 5 (v7l) with 1015956/834552K bytes of memory.Processor board ID FGL2111B21MAP Running Image : 8.3.111.0Primary Boot Image : 8.3.111.0Backup Boot Image : 0.0.0.01 Gigabit Et...
i already have the image
but after i copied the image via tftp got this error message similar of the one mentioned above i a comment earlier :
"Image downloaded, writing to flash... do CHECK_ME, part1 is active part ERROR: INVALID COMMAND PASSED...