Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a 3640 router which has a 8 ports sync/async module (nm-8-a/s) installed. This router is directly connected (back-to-back) via serial 2/0 with V35 cables to an high speed serial interface (WIC-1T) in a 1751 router. DCE cable is connecte...
Hello,I am using an 1721 to connection to a central router. When I try to establish an no call is made. A packet is routed to the dialer interface and mark as interesting traffic but I think the router cannot bind the dialer to a physical interface.D...
Thanks,I am going to try to use the WIC-2T. The problem is that it is not our router and very difficult to arrange change on that.Thank for your information.
My cable is a V35 cable an shopuld be able to handle a minimum of 2 megabits per second. The lenght of the two cables together is 6 meters (2 standard Cisco cables)I still do not understand why the maximum speed is 512000 bits per second
Sorry, but as far as I know the clock rate has everything to do with the actual bandwidth of the link. The bandwidth command itself is used in the routing protocols and to calculate the load.The clockrate is important.I have increased the clock rat...
Hello,Sorry for my late reaction but I was not in the office for a couple of weeks.I have tried to installed 2 different IOS releases (12.2-8-T5 and 12.2-15-T2) but they didn't run because of memory shortest according to the messages. The latest 12.2...
Hello Mak,In the debug information I added deb dialer and deb isdn q931 was active. I made a new call and enabled the the following debug: deb dialer, deb dialer detailed, deb ip packet det, deb isdn q931, deb ppp nego, deb dialer packet.The Cisco 1...
