Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can you please try the below chat script & see if it works?chat-script bestdial ABORT "NO DIALTONE" ABORT BUSY ABORT ERROR ABORT "NO CARRIER" "" "atdt \T" TIMEOUT 70 "CONNECT" \c \r \p\cThanks, Mak
Hi Mohammed,Looking thru the logs & configs it appears that the ppp process does not start, also w have the router configured for ppp call back.We have the following:interface Group-Async1async mode interactivegroup-range 129 136 <<< add this command...
Hi Matt,You need to configure static NAT or Port static NAT on the edge device (could be the 1700 or the PIX based on the setup you have)http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d163.html#wp...
The Frame Relay End-to-End Keepalive feature works between peer Cisco communications devices only, this is a requirement. Do we have 2 Cisco end devices here? Also we need to have matching parameters at either end:http://www.cisco.com/en/US/partner/p...
If I understand correctly these modems were connected on the Aux port of the 2500 & now you intent to connect then on the console port of the 2800, what vendor modems are in use?The below doc has info on router console port configuration, we will nee...
