Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anybody have any insight into the new switchport suppression feature. I'm setup with WLSE 2.11, AP's=12.3(2)JA2 connected to 3560-48POEs.WDS, self-healing, auto re-site survey, rougue detection with suppression turned on. I have one AP Scanner only w...
All,I'm running PEAP, ms-chapv2, TKIP+WEP128, Cisco ACS with certs. I have ~400 clients in production working fine.On some new Dell laptops with XP SP2, the wireless client won't roam and re-authenticate. Tried Cisco ACU only, Windows Wireless config...
I have MS PEAP working with AP1200's and ACS 3.2(1) using MS ADS for the DB. Using MS XP and Win2k, Aironet cards and drivers and third party cards on devices that come built in. Have a Thawte Certificate and all is working from the MS network perspe...
I'm looking at a LRE project that would include 4+ hotels. We are looking at this opportunity as a venture from a providers standpoint. My question is this: Can you use a single BBSM for multiple locations? Would you need to bridge all locations on t...
Anybody seen or used a standard type telephone device that hooks to the mic and speaker jacks on a sound card. What I'm looking for is a standard looking phone for listening and speaking. You would use the onscreen keypad, the phone would only be use...
I suggest setting up an seperate VLAN on your network. Use ACL's at your router to control access to and from this VLAN. Then trunk your AP's to your switches and create a new SSID on this new VLAN. Under this SSID you can setup standard WEP and just...
Also take a look at these hotfixes. They solved some other issues with MS-Chapv2 auths. Not sure it GTC is affected by the sp2 change with radius. But check it out non-the-less. Hope this helps.http://wireless.dweezle.org/PEAPFixes/hotfix.html
You could go with the bulkhead extender at 60".Part AIR-420-002537-060 Bulkhead Extender 60" RG58 type cable with RP-TNC connectors 2 dB lossor try RF Linxhttp://www.rflinx.com/Cables-Connectors-LAR/Cables.htmI found that calling them is most helpful...
My suggestion is "SITE SURVEY". I would start with a diversity omni-directional antenna, somewhere around 6dbi. I assume the door(s) will be open. I would'nt expect it to work to well if the radio is mounted outside the cabin and the doors were close...
I have this config running in production right now. PEAP was difficult to setup and get working. Mainly due to the certificates. I had to load a Microsoft CA server and generate certs for both my ACS servers. Then you have to import them into the pc'...
