Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have had CATC (DNA Center) integrated to ISE via PXGRID for several years now. We had to reconfigure some ISE nodes and moved the TACACS profile to 2 new nodes. I have force a resync by updating the password used between ISE and CATC. However i ca...
I am setting up a new 9800 controller. I have followed the Configure Mesh on Catalyst 9800 WirelessLAN Controllers guide. I have the Bridge configured and functioning. However it will only pass VLAN 10 traffic, it is not passing VLAN 20 or 30. I have...
So the solution was that even though I had set the Configuration / Access points / Mesh / Mode to trunk with a native VLAN the APs were not updating correctly. I had to issue the command ap name (XXX) mesh vlan-trunking native 10, from the controller...
