Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to setup my MX65 to connect to a Inseego FX2000 via the internet 2 port (secondary connection) but we keep getting connection failed on the Meraki side... We current have the FX2000 setup in IPPT mode, but have tried normal router mode and...
I have a Cisco 4506 Core switch and we are wanting to be able segment off one subnet and route them through a different Internet pipe than the default one. What is my best approach to implement this? Access list? Route Map?
I know this will be a very simple question:I have a frac T-1 circuit (256k) that I am going to downgrade to a 56K circuit. Can I use the T-1 WIC or do I have to have a 56K WIC.
I have recently starting having a problem with running out of translation slots. I have 2 global PAT's setup that should give me more than enough. I think the problem is that connection are getting disconnected, even though I have my xlate and conn...
Yes link light comes on, using WAN 2 because we already have a connection to the Primary ISP in WAN1. When we plug directly into a PC, the computer gets an IP and connection to Internet.
xconn value is set to 30min (temp)conn value set to 30min (temp)show xlate doesn't really show anything out of the ordinary..There are multiple hosts, although some host have multiple translates..Shouldn't these xlates timeout after 30 mintues then d...
