Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Has anybody experienced the problem of an access point not sending out its radio frequency? The hard wired network has not shown any problems and access to them via telnet and http is good. The access point has not shown any error messages in the ...
Can anybody help me to find out what an acceptable number of broadcasts is on a switch port in a class c vlan? We had an issue when a device on a switch port was broadcasting continuously which caused the vlan to slow down to the extent that it was n...
Hi,I would like to set up broadcast storm control an a 2950 as follows:interface FastEthernet0/1 port storm-control broadcast trap port storm-control broadcast threshold rising 20 falling 10 switchport access vlan 547This works OK, but I am not able ...
Hi,I have a Linux based server that connects to one port on my 3550 with 4 IP addresses. I have found that some (1 or 2) of the IP addresses are down whilst the rest are still accessable. This happens at an erratic rate with no pattern.From the switc...
I have Campus Manager 3.2 installed and need to upgrade to 3.3 so I can get the User Tracking Utility to work.Where can I get CM3.3 software to update my existing Campus Manager?
The problem suddenly occured on 8 Access Points at the same time. We suspect that it was due to a spanning tree problem, but would like clarity on why the APs shut the rf. If we unplugged the Ethernet, the rf came back, but as soon as the Ethernet wa...
I had a laptop with a configured radio card in it that had worked to the AP previously. We also used Netstumbler to sniff for the rf, but it showed nothing.This was an existing, working installation that suddenly just stopped working. The funny thing...
If your switch supports it (Version 12.1(13)EA1), use the following command on the interface:interface FastEthernet0/1 storm-control broadcast level 5.00This will limit the broadcasts to 5% of the bandwidth.For Version 12.0(5)WC2b, the command is:int...
This could be related to a duplex mismatch. If the server and the switch are both set to auto, usually the switch kicks in at 100/half, and the server kicks in at 100/full.Force both the switch and the server to 100/full and see if it makes a differe...
Hi Milan,Below is a list of the traps I am sending to my CiscoWorks server. snmp-server community publicsnmp-server chassis-id SW1snmp-server enable traps snmp authentication linkdown linkup coldstartsnmp-server enable traps configsnmp-server enable ...
