Buy or Renew
Buy or Renew
runner
Level 1
Level 1
Member since ‎09-16-2002
‎08-18-2017
Recent Badges

User Statistics

  • 7 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
5 Discussion Posts

User Activity

NAT config for IP migration

04-04-2006
Hi, I want to use NAT for IP migration for a number of our servers. All the configuration examples just seem to use an ip nat inside source static statement assuming you want the client to talk to the old IP address. I'm hoping to have a solution i...

PVC aggregation with LS1010

10-06-2005
My current setup has multiple PVCs coming in over a single ATM OC-3 from a public ATM network to a 7200. I was wondering can I throw a LS1010 in the middle and have it do aggregation on the PVCs from the public network down to one or two on the 7200...

3660 - LS1010 - 7206 CRC errors

09-08-2005
I have a 3660 with an ATM DS3 modules in connecting to an LS1010 that then connects to a 7206 with an ATM DS3 module, I'm trying to do bridging with this configuration. The one is setup as bridge IRB the other RBE. When I hook the 3660 to the 7206 ...

show bridge atm measurements

10-15-2002
When I do a show bridge atm5/0.7 I get the following output:Bridge Group 1: Address Action Interface Age RX count TX count00a0.c53f.88b6 forward ATM5/0.7 2 586 6040001.032a.b163 forward ATM5/0.7 ...

make two half duplex lines into one full duplex line

09-16-2002
I have two half duplex point to point circuits both going into a cisco router at either side. I was wondering if it's possible to configure one link to be used to send data and the other to receive creating a virtual full duplex circuit out of the t...
Community Statistics
Member Since ‎09-16-2002 12:45 PM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 7