Does anyone know how to limit the commands available to a single user without giving too much access to the show commands? I believe this should be exec level 6 and below.I created a user at privledge level 0 to only issue command "show ip bgp summar...
I understand CEF is required when using the "match protocol" under a class map. This basically turns on NBAR. Is CEF required for rate limiting when using the DSCP keyword after conform-action or exceed action? also is CEF required for the "shaping" ...
I often see multiple replies for serial and ethernet interfaces for a multicast ping to a group. For example a ping to group 224.4.4.4 will be replied to several times by a serial or ethernet port on one router if the only group interface for 224.4.4...
Working with IPv6 and I received a return code of H. Anyone know where you can find what all the values for the ping reply mean including the H above?Thanks,
the command is located in the wirelesss controller GUI, under the landing page of monitor summary. The access point is down below under the AP distribution. clicking the graph icon in the upper right displays the Access Points by model number.
On a serial interface I would contribute the runts to a timing problem which is not an easy problem to isolate esp. with a telco. Even though there may be no CRC or Frame errors.