Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm doing a network drawing for a company that is using the LS1010 ATM switches. Does anyone know if I can still get stencils for that product? I checked the web site quickly but didn't see anything. I know these are pretty old so they may not be ava...
Does anyone know if there is a command to display the number of power supplies on a 7200? I'm trying to get inventory together and knowing how many power supplies each router has would be useful.
Hello,We are testing the new web based Outlook on a test circuit. The connection is a 64k (32k CIR) fractional T1. Everytime the end user downloads the email, a 1MB file takes over three minutes. When we forward the message with the attachment, it is...
Hello,We have a FRF.8 setup that I am curious about getting CDP working on. I was told it cannot be done because of the link management conversion but I wanted to make sure. Any input would be greatly appreciated. Thanks!
Hello,I have a question about CDP. We are converting our routers to a frame to ATM solution. Since we've been cutting them, I noticed CDP no longer works on the serial interfaces (it worked fine on the frame to frame config). I was just curious to se...
That is good enough for me. I'm in the middle of a WAN re-design and I need to draw up an existing environment that is using some 1010's so the chassis is good enough. Could you email them to me at dpetrucci@ironmountain.com? Thanks in advance!
Thank you for the input! I tried what you suggested and now the circuit will burst up to 44k inbound (about 16k out) during the test. It also seemed like it got to the 44k relatively quickly (whereas before it would take forever just to get to 20k).T...
Thanks for the link! We are mostly running 12.0(16) on regular 2600 series routers. For testing purposes I am trying to get it working on a 2650XM router running 12.2(17). The other end of the PVC is a 7200 and the 2650 is showing up in that router a...
Thank you for the link. That is good information. Unfortunately, we are still stuck in the same situation. I have cdp running on both the head end (ATM) and the access site (Frame-Relay) sub interfaces but I am not seeing the neighbors on either rout...
