Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
please help with following question.
I have a 5510 ASA in standalone mode, but going to change it to failover. I have another ASA, but with security context support, ASA 5510sc. Is this a restriction for failover connectivity? As I ca...
Dear community,
kindly ask your help.
We have two ISE, working together in one node group as primary and secondary. After total crash of database we re-install these two ISE nodes and recover first one from backup. So, now we have one recovered node ...
Hi,Not sure why do you need so many areas, however it is your choice.Try to simplify the design by configuring all your switches as backbone routers first (all subnets/interfaces belong to area 0), if you need multi-area design (for summarizing and s...
You don't need to create 2 IP SLA to switch the routing between two ISPs. Just create one entry to track something in Internet and add the track to prefferable ip route to ISP1 (wired, I guess) from interface going to ISP1. Add another ip route with ...
Check speed settings on interfaces you are using to establish neighborship. Would be great to check the same on neighbors. Hardcode it on both sides if you are going to use 10g
.....when i ssh on router from directly connected switch i prompted for only a password which is none of the above passwords .....
When you use a built-in ssh client (trying to connect from switch CLI), it use your current username (that you used ...
