Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi again,I was wondering if there is anyway other than using ANI TCL application to stop the user calling on ANI. We are connected to PSTN via E1 and wants to block a certain range of numbers, 311001 to 311051. What are my options ??? i can't find an...
Hi,5350 is configured with T1 PRI. i did the debug isdn q931 and i found this message in every call. Calls are coming and going out properly. A little debug isdn q931 for your consideration:*Mar 21 08:29:35: ISDN Se3/0:23: overriding plan/type for 02...
hi,I have a 5350 connected to PSTN via T1 PRI. when calls comes or send to PSTN i see a plan type message for every call. I have also configured 5300 in some other locations connected with E1 PRI with the same config but i dont get such messages on ...
Hi all,I was wondering if its possible to configure 5350:1- 1 E1 for both VoIP and data calls handling ?? if yes what will be the config ?? if not then2- 1 E1 for VoIP calls and other E1 for data simultaniously ?? if possible what will be the config ...
Hi All,I have some ATA186 in different locations. All Sites are connected to Internet and have some spare IPs to provide it to ATAs. I go through by documentations for configuring ATA but still have some confusions about it.Queries are:1- ATA needs C...
Hello,This error indicates the ISDN T310 expiry before the call get connected. first check this timer by SH ISDN TIMER and see what it is. Cisco recommend it to be 60 sec. you have to put the value in msec. Here is the link with detail:http://www.ci...
I guess your solution will solve the issue. I upgrade one of my 5300 to 12.2(15)T and it have permission command. One more good news it also have the Class of restriction ;). Hope i will get the solution following your steps. Thanks mate.! di...
Hey, thanks for your attention. I was thinking to give some more details on network topology.Originating site--------------------Internet--------------------Terminating sideE1 PRI (basic-net3)-------------------------------------------- T1 PRI (prima...
hi!thanks that you care to answer. yes i wanted a working config for inbound calls. here what i did and it worked....!voice class codec 1 codec preference 1 g723ar63 codec preference 2 g723ar53 codec preference 3 g723r63 codec preference 4 g723r53 co...
Above solution is good and easy.If you are ready to dial other number to get translated to original then the solution could be a translation-rule in dial-peers.Exampletranslation-rule 9 Rule 1 ^52122% 22!!dial-peer voice 22 voipdestination-pattern 5...
