Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Actualmente tengo en una sede 2 HOST físicos con 3 maquinas virtuales cada uno, un HOST con un CUCM Pub, UNITY Pub y PRESENCE Pub y el otro Host con el CUCM Sub, UNITY Sub y PRESENCE Sub y ahora quieren separar este HOST secundario en otra sede y hac...
Actually I have a Nokia22 designed to be connect to PBX extension system. That device has two analog interfaces: trunk and extension. I have tested with succesful results the Nokia 22 connect to a PBX extension. Doing the following steps:* User dial ...
**Does anybody tested the configuration mentioned on the document http://www.cisco.com/warp/public/794/827cnfg_faq.html#16 ? The following document will help too http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/827/827swcfg/routcfig.h...
Hi everyone,Is there anybody who can tell how may simultaneous vpn can i create with a PIX 506?I understand for a vpn 3 SA's one for IKE and two for IPSec.Thanks a lot
Hi everyone this is Albert. Could anyone help me with this issue?I'm trying to configure trunking with FastEtherChannel (2 ports) between a cisco catalyst 2900 xl series and a HP Procurve 4108 gl where in the specifications says FEC is supported but ...
Hi,it is a very important concern to install Telephony IP on HP switches cause VLAN ID must be fixed on all ip phones and ATAs. Imagine an implementation with 1000 ip phones.On ATAs is more complex to do it cause Opflags and VLANSettings must be fixe...
Hi Oscar this is Albert. Could you help me with this issue? Is pretty similar with the 3Com case:I'm trying to configure trunking with FastEtherChannel (2 ports) between a cisco catalyst 2900 xl series and a HP Procurve 4108 gl where in the specifica...
Are you sure there's no way to dial from an analog modem to an ISDN line connected to a Cisco 801? If you connnect the ISDN line to a server and you use an analog modem to dial in and to connect to the server it funcitons OK, so why you can´t do it w...
