Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear,i installed Cisco 1562 -E -M with WLC 3504, attached two external antennas (port 1,2) however the signal is very week, any settings should i change to increase the wireless signal? regards
Good morning,
we have CME 2901 router, no FXO module installed, we have GSM device to convert from GSM to RJ45 Huawei (B315S-936), need to configure the CME to get the incoming and out going calls to the Ethernet interface, as i know you can do dai...
What firmware is the controller running on? 8.10.142What antennas are attached? 2 Antennas AIR-ANT2547VG-NHow high are the APs installed? about 4 metersWhat is the distance when you were measuring "weak signal"? inside a sandwich panel cabin about 8 ...
