Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI want to prevent the spread sasser and blaster at the network layer in my Cisco routers .What commands do I key in to get this done?Please help .This is urgentthanksShiva
HiI would like to know the number of calls made through my 2620 router(2 fx cards) .Is there any software tool which can extract this data and provide data graphically ..etcregdsShiva
Hi freindsI am newbie to VOIP..Plz help me on some doubts I have.I got 2 FXs cards installed on the both side routers.I have pulled 2 analog trunk cables to Epabxs at the both ends.1.Can I conect FXs cards to EPABX ?2.Can I use the existing digital ...
Hi I am a newbie to VOIPMy situation is something like this..We have two offices (WAN link) and we need to have VOIP through this WAN link.I happen to discover that the WAN link router has VIC-2FXs card installed on the router.1.What is the solution ...
HIYou can use a pix firewall(525 or 535) with more than 2 interfaces .The number of ethernet interfaces should be equal to the number of vlans (theres a limit though to the number of ethernet cards a pix 515,525,535 can support)and and routes ,nats ,...
Hi,1.The Pix outside and the rooouter inside should be in the same network ie 192.x.x.x 255.x.x.x2.I dont see any route statement in your pix conf.Please add the routing statements you should be throughAll the best!
Thank you very much .It worked by doing what you said.now the Routing table is as follows in my pix: outside 0.0.0.0 0.0.0.0 x.x.x.x 2 OTHER static inside 10.1.1.0 255.255.255.0 172.16.10.10 1 OTHER static inside 172.16.0.0 255.255.0.0 172.16.0.1 1 C...
