Hello all,
I need some assistance with creating some ACLs. In my environment I have a few vlans 192.168.101.0/24 - 192.168.105.0/24 (.102, .103, and .104 are in there as well), as well as the default vlan 192.168.1.0/24.
What I am trying to do is...
Hello All, I need a little assistance with getting my vlans from the switch to make it to the router and back - or simply put, my vlans (other than the default) cannot reach the internet. On the switch side, I have changed it to router mode (layer 3)...
Hello All,
I need a little assistance with getting my vlans from the switch to make it to the router and back - or simply put, my vlans (other than the defualt) cannot reach the internet.
On the switch side, I have changed it to router mode (laye...
Hello All,
I am trying to setup an office building with 13 Vlans with ACLs to help keep traffic segregated. For now I have created all the VLANs and assigned them IP addresses. My issue is that I cannot get out to the internet as a member of one of...
Jeremy,
What problem are you having specifically? For me, the next hop was incorrect and I could not reach the router from any of the devices in any of the VLANs.
Here is a link to the post I created on the side.
https://supportforums.cisco.c...
The router (and dhcp) is at IP 192.168.1.1.
Here are my ACLs. I applied them, but had to remove them until I can get this sorted out. Also, I attached my switch and router configs (the switch shows the IP helper addresses, and the router has all t...
Francesco,
Will I need to allow the DHCP service to get through the ACL? As of now, my PCs are not able to obtain an IP from the Router at 192.168.1.1 (which they do before I implemented the ACL)?
john
ok, thank you.
Any reason why I get "unrecognized command" when I apply the acl to the vlan?
ip access-extended 104
int vlan 104
ip access-group 104 in
"%unrecognized command%"
Hello Francesco,
Here's what I get when I try to enter the command:
CoreSwitch(config-ip-al)#permit ip 192.168.105.0 0.0.0.255 host 192.168.1.1% Wrong number of parameters or invalid range, size or characters entered
Am I entering it incorrect...