Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Boot Sequencing is not working on Catalyst 2960X series switchBelow are the sequence i have done on the switch :boot-start-markerboot system flash:c2960x-universalk9-mz.152-7.E9.binboot system flash:c2960x-universalk9-mz.152-7.E7.binboot-end-marker
I am using C-2960X series switch on my production environment .I have uploaded the following image from tftp c2960x-universalk9-mz.152-7.E9.bin on the switch and made the boot sequence done by executing following commands .boot-start-markerboot syste...
Hi Ivan ,I am using C-2960X series switch on my production environment .I have uploaded the following image from tftp c2960x-universalk9-mz.152-7.E9.bin on the switch and made the boot sequence done by executing following commands .boot-start-markerb...
Hi,Might be problem occurring during traffic reverse path verification time. Could you please check once remove the below command.ip verify reverse-path interface Cogent100Mbps
