Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 3750s configured in a stack with 2 vlans - vlan 1 and vlan 99. I have setup inter vlan routing which works fine. I have been trying to get a default route to the internet to work using a routed port to no avail. I have set my workstation to ...
HiI have configued a Cisco 1760 with an ADSL WIC that is connecting to an ISP. The ATM interface appears to come up and I can see the CHAP authentication getting a success, but I can get no traffic through the router.If I ping anything I get a failur...
I have a Cisco 2851 with a NM-1CE1T1 PRI interface that I wish to utilise for dialin. I have followed some configs on here, however cannot workout the correct line commands.If I try to add a line via i get an error that it is not supported in hardwar...
I'm having real issues getting this working. I have configured the router as below and am using the Cisco VPN client 4.6.02.0011I get an error - %CRYPTO-6-IKMP_MODE_FAILURE: Processing of Aggressive mode failed with peer at xx.xx.xx.xxand the VPN the...
HiAll GLBP documentation points to doing it on multiple routers.Would it be supported in a configuration where the 2600 has 3 ethernet ports, 2 for WAN and 1 for LAN with the GLBP being done on the 2 WAN ports?I'm looking for an inbound/outbound load...
My config is very similar to http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008015f17a.shtmlI have 2 VLANs on a 3750, VLAN1 and VLAN99. VLAN1 is 10.61.30.1 and VLAN99 10.61.39.1. IP routing is enabled and a defaul...
device is a cisco 1841 routeryes the interface has been used before, i have not cleared the counters and due to the fact it drops a portion of the network when i enable the routed port, i have had to revert it back to a switchport.
No, i cannot ping 10.61.38.2Heres the dumpsnterface IP-Address OK? Method Status ProtocolVlan1 10.61.30.10 YES NVRAM up upVlan99 10.61.39.1 YES manual up ...
cool thanks. I didnt think GLBP would work like that but was hopeful!I need an inbound load balancing solution and was hoping to use existing equipment.
