From what I’ve managed to read in various threads that a search returned, I need to “forward a port.”
Problem is that none of the following threads I read:
https://community.cisco.com/t5/routing/port-forwarding-nat/td-p/2102914https://community.cis...
I’ve yet to actually get an answer that has helped me over the past few months when it comes to getting a 4321 router working as a router.
This is simple simple stuff that I need to do (I just need the functionality of a $30 router – I’m paying for...
I found a site that explained how to set up DHCP in English instead of gobbledygook but it appears that something has changed or they made a typo or two: http://www.firewall.cx/cisco-technical-knowledgebase/cisco-routers/812-cisco-router-dhcp-config....
I want to change GigabitEthernet 0/0/1 to 192.168.1.254 from 192.168.2.254 on the 4321 router with Configuration Professional Express 3.2.5 - it clears out the address when I try, but will accept the .2.254 when I put it back.
So bug, or feature?
There needs to be a simple graphical interface to get these units going.
Eventually we will be using the more advanced features of this unit, but right now we just want to get it running as a router.
I have figured out how to talk to it through a...
@balaji.bandi wrote:
You need to give access from right from internet router to end point
as example :
Internet ---DSL you need to forward here ---your local router (same here) -Switch -Camera
when you scan it will be dropped at DSL router end.
...
Did not work. Below are the commands I entered (the "$" at the start of the port 10544 command line is TeraTerm "shrinking" the line on the display - the full "ip nat inside source static tcp" text is still there):
Carlton_Router#Carlton_Router#con...
For some reason I can't see the text of your message here (but it is the email that notified me you responded.)
I'll C&P the relevant portion from the email:
"ip nat inside source static tcp 192.168.2.240 80 interface dialer 1 80In this example w...
@balaji.bandi wrote:
Need some clarification here :
You want to open below ports from Internet to internal network to this IP (NVR’s IP address is 192.168.2.234) ?
I need to open ports 81, 8001, and 10554 on a 4321
From where your boss try to a...