Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I recently came up into a configuration applied on a router that looks like this:
policy-map wanclass ether-wan-telephonypriority percent 15class ether-wan-videopriority percent 10class ether-wan-signalingpriority percent 5class ether-appsbandw...
Hi everyone,I want to calculate the percentage of errors on an interface and I have searched a lot of posts and some people divide output drops by output packets, and some by output bytes. And some also add the OD on the denominator. What is correct?...
I have a nexus 3172T in vtp client and is running nx-os 7.0.3.I7.6I want to turn vtp mode off or transparent, but apparently I cannot do it. It does not give me any options to do it.I read in another post that vtp in client or server mode is not supp...
We have several 887-VAG with this errorthey are running c800-universalk9-mz.SPA.157-3.M4a.binI see there was a bug https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvd23231 but it only affected 15.2and the workaround was to make vtp trasparent.it is a...
Hi thanks,I applied this command and my drops are zero.From my understanding the drops were due to microbursts and the low buffer size of 9300 egress queue which is shared by many ports.
Hi Giuseppe, this is a switch. If you look at the number it cannot be packets, because then the number of packet drops would be larger than the output packets, which means my packet loss would be > 100%
the device is nexus 9300 GigabitEthernet1/0/x is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 70d3.7985.a68c (bia 70d3.7985.a68c)
Description: xxxxx
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliab...
