Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have setup two wireless bridge BR350 to link two sites, which distance is about 7KM. The configuration is very simple, one side is Root bridge and the other side is non-root bridge w/o Clients, no WEP implemented, the speed here has been fixed to ...
I found that UserTracking can capture MAC info. from the switch port which individu VLAN has been assigned, but can not capture MAC from the switch port which was configured as trunk. Why? As I know the switch actrually maintain a MAC table with info...
One of my customer who are using Ciscoworks 2000 to manage the network equipment, recently some Catalyst 2950 and 3550 series switches have been installed. After adding the device package to Ciscoworks 2000, the CW2000 still can not recognize those ...
Through the link test in the Bridge web interface, we found that the signal strength is only 1%, any due to IDA Singapore policy we only can set bridge power to 1mW. Is it the normal signal strength display or we need align antennas? If the alignment...
The version of Campus Manager the customer use is 3.1. I only found IDU for RME 3.3, no IDU for CM3.1. Is there a way to upgrade ver 3.1 to ver 3.2.I downloaded the IDU for RME 3.3 and installed, the CM3.1 still can not recognize 2950 and 3550.
