Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there some way to change the address the WLSE sends the e-mails from for fault notifications or other system info? Ours just says [email protected] right now and we'd like to change is to something like [email protected].
I have a question about setting up VLANS on the AP's. I've configured a user VLAN on an AP w/ 12.02t1 code. I've also tied a new SSID to the VLAN. I'm trying to migrate users from our old configuration where broadcast SSID was available to a new c...
I'm having a problem that started recently with my WLSE. Whenever a fault occurs with an AP, I receive the standard "Device was not reachable by SNMP" error message. I'll check out the problem and correct it but the fault will not clear from the "D...
I have a serial line that bounces periodically. I've had the carrier test it extensively with no problems found. Today I turned on "debug serial interface" and I see the the hdlc keepalive sequence messages. I'll see the interface miss 3 keepalive...
Thank you for the link. I found a similar document last week that explained the difference b/w the primary and secondary SSID's. Only one SSID can be broadcast in the beacon frame so I can setup that SSID as the primary and include the new SSID's a...
Thanks for your response.I know about the acknowledge feature but I'm talking about faults going from an active state to a cleared state. I believe it must have been something in the 1.3 code.I've upgraded to 1.3.1 code now and the faults will now m...
