Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a network design issue to solve and need some help. Current network uses ISL to trunk vlans between two sites. Some encryption devices need to be installed that do not understand ISL (or BPDUs for that matter). I need to split the ISL, or tunn...
I have set up a cisco vpn client(latest)to a test network terminating in a 2611. This all works ok and I can see packets coming off the router onto the destination network. The destination host arps for the sending device (IP of the VPN client which ...
HiWe have a 3640 with a PRI card installed and 12 Mica modems. This router is set up to use RSA secure authentication by way of the RSA radius server. This works ok and users can get in. The issue is that users are not de-authenticated when the line ...
Thanks Chaps,I believe that my best option is to offer the Customer two choices:1. Buy some routers and use L2TPv32. Upgrade the switches and user 802.1Q tunneling.All the best ... Josh
Yep, that's the problem. Crptos do not natively support dot1Q so I was hoping to use dot1Q tunneling over an un-tagged link where the crytos sit in the un-tagged bit. No challenge there then (-;S'pose the first question is do 2690 switches support Do...
Hi, Thanks for replying!Ordinarily, I would agree with you but the end Customer only wants the link segments encrypted. I am currently looking into 802.1Q tunneling. Is this usable on 2960 switches and is there any gotchas to watch out for? Topology ...
Many Thanks (-:Although this was not the complete solution, it did point me in the correct direction:The router required a route back to the VPN network. This cannot be configured to the Virtual Interface but will work if you point to the real interf...
HiIf it is a small switch or only a couple of users you are interested in then I would be tempted to use the old method of noting the existing linklight status of all the switch ports, disconnect the user and spot the difference at the switch. Plug t...
