Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,
We have some confusion about AP Bundle image upgrade.
Situation:
1.our Wireless controller is running with 8.2.166.0 version we are planning to move on 8.5.135.0.
2.we have running AP model is 2702,3702, and 1572.
3.i have read out rele...
we have 2 vdc in 2 physical box(7718) and vpc between theM but when i am pinging vdc1 l3 vlan getting high latency and while pinging vdc2 l3 vlan ping hop are fine.
SW01 vdc1Reply from 10.142.33.2: bytes=32 time=3ms TTL=255Reply from 10.142.33.2: ...
Hello,
the issue got fixed by implementing one solution on our nexus device.
as previous, we were running Pvst and we have approximately 150 L3 VLANs, and 150 access layer neighbor.
This situation was creating multiple logical ports in the device a...
Hello Georg,scenario is like this.VDC1 have one L3 vlan and same L3 vlan is at VDC2 and hsrp is also configured.vdc1 vlan111 10.31.2.2vdc2 vlan111 10.31.2.3hsrp vip 10.31.2.1
Hi NPT,
This is comman issue in this device , you have to take switch to switch: mode first.
then process is :
1.switch:FLASH_INIT
2.switch:dir flash:
you will get flash file information there .
3.boot flash:packages.conf
i hope this will h...