Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi When I ping from PE1 to PE5 by "ping mpls ipv4 5.5.5.5/32" command, FEC target is When I ping from PE1 to PE5 by "ping mpls ipv4 5.5.5.5/32 fec-type generic" command, FEC target isI am bit confused about these 2 diff FEC target . Could someone ex...
Hi ,Can anyone share nexus document of MPLS VPN's over mGRE.I tried traditional commands of MPLS VPN's OVER mGRE however those are not being supported in nexus. Thanks in advance
Hi all,I have been trying to make better understanding on remote-LFA.I read below sentence in some document..P space :-it is the set of routers that S can reach without passing through the link SE (including ECMP)Would anyone mind to explain that wha...
Hi all, Can anyone please explain the difference between following QOS marking matrix?1)QOS group.2)Discard-calss3)Traffic-class. I noticed that somewhere QOS group is used and in some other examples discard-class or traffic-class are used. I am not...
Could someone explain about FEC type generic and and usage about it.I have seen this option along with MPLS ping command but not sure about the usage of it.
Thanks for reply .MPLS link has currently been terminated on nexus box.Hope you meant there is no equivalent Commands ( l3 VPN encapsulation profile name )on Nexus for MPLS over MGRE and options is that configure MPLS over DMVPN.
As per attached diagram, from 3.3.3.3 to 6.6.6.6 Primary path is via R5 .As per remote-LFA, does R4 fall to P-space(We have ECMP towards R4)?AndDoes R2 fall to Q-space (We have ECMP towards R5)?Thanks..
Hope (INT VLAN 1) ---- [IOS CPE 3650 CX] is having access port. If it is access port then it always expect IEEE BPDU from far end.When processing received BPDU on access-port, it must be IEEE standard BPDU otherwise a type inconsistent state is decla...
Hi Giuseppe Larosa, First of all thanks for your response. I have been seeing two routes one from PE-1 and another from PE-2 in the show ip bgp vpnv4 vrf xxx database in the situation 1 and situation 2. But only the best path is being imported to sh...