Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am getting confused on what happens in these 4 instances:1) Recieving a BPDU on a globally enabled Portfast port
2) Recieiving a BPDU when Portfast was enabled per port basis
3) Recieving a BPDU on a globally enabled Portfast port with BPDU G...
Hi,
I am currently reading how the election process takes place, and am confused a bit. This is because, on one slide there is that Router priority is taken first preference for DR/BDR election and on the other there is that the preference is taken...
Hi I am doing lab http://www.smartpctricks.com/2014/04/redistribution-between-eigrp-and-ospf.html
and am finding it difficult understanding the part where redistribution of EIGRP is occuring into OSPF.
There's the command:
router ospf 1
redistrib...
I have a question about the Speak state description as per the following: "The router sends periodic hello messages and actively participates in the election of the active and/or standby router. A router cannot enter speak state unless the router h...
So to sum up the attached, as that part is still not clear for me, basically portfast will be disabled both in if configured globally and per port, but
1) When configured globally, portfast will be disabled and it will go into blocking phase and ru...
So in that case, it should have been a cost of 64 if it is referring to the N6 link right? But in redistribution is it doesn't have to be precise as it's just have to be a good start metric.
