Hi,I'm seeing a strange problem in an environment where two routers ( cisco RPM's) that are connected in an isolated environment and are configured HSRP on the interfaces. They both were configured to have equal priority for a reason and sends hello ...
I've a simple network with two ethernet switches and are connected each other with etherchannel on two gigabit ports. I had enabled Portfast-Trunk feature on both to reduce the startup delay. And i want to find out that any voilation of the etherchan...
Hi,I want to setup simple ACL which blocks all incoming traffic initiated into our network through (WAN) serial interface. And allow the outgoing traffic from our network to the world through Router ethernet interface which then puts onto WAN serial...
Hi GP,Here is my config that is relavant for the interfaces.Router1:interface GigabitEthernet1/0 ip address 10.18.1.15 255.255.255.0 no ip redirects no negotiation auto no keepalive standby delay minimum 140 standby 1 ip 10.18.1.14 standby 1 timers m...
Kevin,I have been following the document for long time. Yes. it's very helpful. Based on those suggestions, it should have workedCurrently i'm working with Cisco. It seems there is a problem with the code, but not confirmed yet.It's still mystery to ...
Kevin, I think you are on it, what i'm trying to achieve. Yes I was optimistic based on all my readings about the RSTP and other cisco features to reduce a startup delay in conjunction with the RSTP.HEre are more details on the setup. Under normal st...
Thanks for your reply.I meant loosing the active switch is loosing power. And restoring the switch means restoration of power. My servers are RS/6000's running AIX with dual NIC. And one other box that is a cisco GW with two routers in it and they ar...
