Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just purchased a brand new AIR-AP-1852E-F-K9 32 Unit for our branches
I connected the AP to the POE and it gets an ip.
But the CiscoAirProvision SSID won't show up. After a lot of research I am a little bit confused.
Maybe someone can help me....
I have FXO card and i install to router 1760 error message :*Mar 1 00:00:07.407: %C1700-3-BAD_EEPROM_VERSION: The eeprom version field hasan invalid entry ()*Mar 1 00:00:07.411: %C1700-3-BAD_EEPROM_VERSION: The eeprom version field hasan invalid en...
Dear all,I have cisco router 3745 on slot 1 i put module NM-2V and 2 VIC-2FXO its no problem and i put again one module NM-2V and 2 VIC-2FXO on slot 3 if i run command sh diag my VIC-2FXO on slot 3 cannot detect..i capture sample "sh diag" on my rout...
I have 5 vic-2fxs made in usa and 5 vic-2fxs made in my mexico,if i install vic-2fxs made in USA on router 1760 I which have enhance PVDM, Dram and flash and also IOS voice-plus ip there no problem but when i change vic-2fxs with made in Mexico this...
Dear all, I new member in this forum, I will enquire a little, I have Cisco IDS 4210 in my office, problem that happened every 3 hour always error like following Error: sensorApp not responding, please check system processes, pleasseee anyone can hel...
Hi Rasika,
Thanks for your respond, solution for my problem only converting our AP to Mobility Express Mode is that correct ?, but i just customer and hope when i buy this device i can setting using Mobility Express mode, i can't download the tar f...
thank's to reply my post,i already swap the slot or vic but still problem,i try to install FXO card to my router 1760 and error message like above:*Mar 1 00:00:07.218: %C1700-3-BAD_EEPROM_VERSION: The eeprom version field hasan invalid entry ()*Mar ...
Ok, Thank's Guys my company last week already sign maintenance contract with cisco (SmartNet) i see when i browsing to cisco website to upgdare memory from 256MB to 512MB is FREE with Smartnet is that correct..? if My IDS already upgrade i try to kno...
ok this is show ver my IDSApplication Partition:Cisco Systems Intrusion Detection Sensor, Version 4.0(2)S43OS Version 2.4.18-5smpbigphysPlatform: IDS-4210Sensor up-time is 1:31.Using 257503232 out of 261312512 bytes of available memory (98% usage)Usi...
