Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does anyone know of a MIB, or a clever method of using the EEM to monitor if the Client VPN service of an IOS router is available? I am trying to find a way to be alerted by my NMS if my users are not able to connect via the Cisco VPN client b...
Hello, I am a bit new to CallManager Express, and I could use some help understanding DSP allocation. I just recently upgraded to CME 7.0 and would like to test out meetme conferencing. I have a 2821 router with a PVDM2-32, a VWIC-1MFT-T1 for my prim...
Hi All,I am looking for some opinions about what and how I should be monitoring in a very small network. For example, if we have four routers and four switches with each running the firewall feature set and acting as a firewall, what should I be mon...
Hi all,We have a small Callmanager Express implementation with Unity Express. We are forwarding voicemail to folk's email, which is working fantastically. However, the voicemail is left on the CUE system.Is it possible to forward the message to ema...
Hi all,I have a 2811 router connected via one of it's FastEthernet ports to a managed Cisco router which provides Internet access for us.I would like to use QOS to give traffic to certain key websites priority over other traffic. I am familiar with ...
Hi again jclarke,Thank you again so very much for this script. I am going to dissect it and use this as a chance to learn all about EEM.I really can not thank you enough for the tremendous amount of effort you have put forth to help me out!-Eric
Hi jclarke, thank you very much for your reply and for the link. I have been meaning to look into EEM a bit more; I will definitely review your link!From the "show crypto map int multilink 1" output I would expect to see:#sh crypto map int multi 1Cr...
Hi Jclarke, thank you for your reply.A few of the IOS commands I would use are:show crypto engine brief To make sure my AIM is working, I would make sure I see the line: State: Enabledshow crypto dynamic-map and show crypto map interface [Outsi...
Hi Java,I wanted to thank you again for your help yesterday. Reducing the T1's channels did the trick and let me activate the conference.I have a question now, is it possible to have a conference always be active? For example, after you press MeetM...
