Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am unable to issue the command auto qos voip on the interface fa0/1. I am also not able to see the command using the "?". But based on the Cisco documentation, the IOS is able to support that command. Any can help or have any ideas? Here is...
Hi, when i tried to do a backup with my ACS SE, the backup always fail. Even when doing it manually, it won't work. Any advice on the settings for it?I'm using a Cerberus FTP server. Connectivity is ok..but i do not know why the connection always dro...
I have a problem with the WS-X4148-RJ. When i insert the module into at Cat4506, this error message pops upSeeprom Not ProgrammedHere is the show module of switchChassis Type : WS-C4506 Power consumed by backplane : 10 WattsMod Ports Card Type ...
Hi guys, i have a problem when using the Cat 3750 series switches. Problem 1: When a user is connected to one of the port of this switch, the user PC is able to grab an IP but unable to surf net or the intranet. After shut and no shut the port, the u...
Hi ppl, I have a problem with in my workplace network. My users are experience slow network during a certain period of time. But during normal hours, the network is ok. There is no high CPU utilization on CORE, Distribution and Access layers switch. ...
I have swap another working WS-X4148-RJ to the slot3. The same error message occurs. This problem started not long ago. Previously it was working fine. Even after taking out the module, the error message is still there when I do a show module. Below ...
I don't think its a hardware issue for the module. As I have switch the position of the module from slot 3 to slot 6. And the module is working ok. Since you say there is no bugs related to this..i guess the problem lies with the Chasis?
