Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to register Cisco IP Communicator in my CUCME but i am not able to find CIPC in device type.
How can i register it.
#show telephony-service:
CONFIG (Version=11.6)=====================Version 11.6Max phoneload sccp version 17Max dspfar...
We have BGP peering with two ISP's (ISP A and ISP B). Both the ISP's are connected on a same border Router on different interface.
We are receiving default-routes from both the ISP's. We have advertised our IP prefix to both the ISP's (103.XX.XX.X...
IPv4 Crypto ISAKMP SAdst src state conn-id status103.81.XXX.XXX 206.208.XXX.XXX QM_IDLE 20324 ACTIVE103.81.XXX.XXX 206.208.XXX.XXX QM_IDLE 20293 ACTIVE
Duplicate session with same destination and same s...
I am facing issue with crypto session on my 4331 ISR Router.
Whenever the ISP internet routes get flap , i need to clear crypto session to make interesting traffic flow.
However some of the remote private subnets are reachable at the same time and s...
We have BGP peering with two ISP's (ISP A and ISP B). Both the ISP's are connected on a same border Router on different interface. Both ISP are directly connected and connected routes can be seen in routing table.
We are receiving default-routes f...
There is no CIPC in device types,gives following error.
VNPVOICERT2(config-register-pool)#type CIPC ^% Invalid input detected at '^' marker.
.................................................................................................
#These ...
can i do same as u told if i have two /24 prefix from different range and cannot aggregate those prefix into /23.if yes i can buy one more /24 and do load balancing
Hi Jon,
I also think my ISP's will not advertise /25 .
What will be effect if my router advertises /25 to both ISP (one to each ISP) ,and both the ISP advertising /24 instead of /25
