Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking at the process to upgrade an ASR 1001-x, currently 16.9.2. Doing some research this looks to be not the old way of uploading the bin, changing the boot var and performing a reload. I have a few questions.1. the document shows a "subpackage" i...
Configuring ASR 1001-x to use LDAP. what is interesting is that I add the servers, two, and the config shows up as being configured. When I next add the servers to a group, "aaa group server ldap LdapGrp". it will return ok. Next in the ldap server g...
I am currently configuring a simple 802.1x POC on a nexus 9K switch. The supplicant is a windows 10 and the Authentication Server is a Win Server 2016 running AD and NPS. I have everything working with another cisco L2/L3 switch but cannot get this w...
I have radius configured and when connected it does authenticate and am able to login successfully.
Problem is that when the radius server is unreachable I should be able to login using the local login, but it fails with the following message;
"Rem...
Thanks, it makes more sense now. Do some more research basically .bin=bundle mode, .conf=Install mode. Looking at my system it has the .bin so I am using Bundle mode, which is interesting since it came from cisco and I thought Install mode was the d...
Thanks for the step by step. Would your steps be the way to go? I will look into the ROMMON, don't see it mentioned in the document. I looked at the "install" method and the steps it takes. Since I have redundancy configured I thought I would use the...
thanks for the information. Its starting to make sense. Looking at the "install" command documentation, I see 2 types. 1. Super Package install—Applicable to Dual RP2. Sub-package install—Applicable to Dual RP Not sure what the difference is, or mayb...
I have a couple additional comments.1. How do you tell if you need to upgrade using subpackages? when I run "sh ver installed" it shows package, so I am assuming that i must upgrade using subpackages.2. I noticed that the web GUI has an area to uploa...
I little more info I have discovered. This is strange. I configured 2 ldap servers then created an ldap group and added the two servers into the group. When doing a "sh run" the servers show up, but no ldap group under the aaa section. When I run "sh...
